Demountable Pulley

01 — Overview

L 280 mmNeoprene spoolInstall tool

Code: SYN-T1-DP-280
Type: Type-I — Helix type (Heavy duty)
Drawing: TEC GR 11.16

Rubber-lined pulley for pulling cable through the alignment.

An installation tool rather than a fixture. Hung from the pole while the cable is pulled, then demounted. The spool contour is coated so the cable runs free without the sheath being scuffed by a bare steel groove.

02 — Specification

Data sheet

Figures quoted from the governing GR drawing tables and Annexure A. Values marked (P) pending production data.

Overall length (L1): 280 mm
Body width (W1): 50 mm
Overall width (W2): 92 mm
Pin diameter: 12 mm
Drawing: TEC GR 11.16

03 — Bill of parts

01
Hook
Galvanised steel
02
Body
Galvanised sheet
03
Spool
Aluminium coated neoprene

04 — Why it's built this way

Coated spool contour for free movement of the cable
Demounts after the pull — nothing left on the pole

Same type

All Type-I →

SYN-T1-TPADRG 11.1

Hover · parts separating

Tension Pole Assembly

→

The complete dead-end set for a tension, angle or splice pole.

Above 10 kNAngle > 15°Matched set

SYN-T1-SPADRG 11.2

Hover · parts separating

Suspension Pole Assembly

→

Armour grip suspension for intermediate poles on a straight run.

Intermediate polesElastomer padSVD both sides

SYN-T1-AGSDRG 11.3

Hover · parts separating

Armour Grip Suspension Set

→

Ball-ended armour grip helix over protective helix, in a die-cast clipper.

15 rodsØ 4.25 mmBall-ended